• Very high-quality, universal, low-stress setting, self-levelling, cement-bound levelling screed.
• For very high loads.
• For producing quickly usable and ready-to-install substrates.
• As composite levelling layer on mineral substrates, ceramic tiles, natural stone coverings, terrazzo, screwed wood-based panels (V100 P4 - P7, OSB 2 - 4).
• Can be used in layer thicknesses from 2 to 50 mm.
• For subsequent floor covering work and the laying of parquet.
• Pumpable.
• The product can be used on underfloor heating and is suitable for use with chair castors according to DIN EN 12529.
• For indoor use 
• Very low emission laying material, certified according to EMICODE EC 1 Plus.

• The substrate must be permanently dry, resistant to pressure and tension, free from cracks and dust, even and free from layers that reduce adhesion.
• Adhesion-reducing layers, old material residues must be removed by suitable mechanical measures in accordance with the specifications of DIN 18365.
• Old fixed floors, such as ceramic tiles, terrazzo, stone floors, are to be professionally cleaned with Eurocol 891 Euroclean Basic and sanded matt after drying. 
• A primer coat of Eurocol adapted to the substrate is to be pre-coated. Allow the applied primer to dry thoroughly.
• Cracks or joints (except structural expansion joints) must be closed with Eurocol Europlan 913 Silicate sealing compound.
• Appropriately dimensioned Eurocol edge strips are to be used for rising building components.
• In the event of defects, objections must be reported in writing.

• Mix the powder in the specified quantity (see technical data) with clean, cold water using an electric mixer to form a smooth, lump-free mass. 
• It is recommended to keep a maturing time of 2 - 3 minutes.
• When pumping, set the mixing device so that a correct quantity of cold and clean tap water is added. Determine the spread size! Rinse the machine and hoses also during breaks to prevent hardening within the machine system. Please consult your pump manufacturer.
• Avoid overwatering, as this leads to sedimentation and the formation of unstable surface layers. Drying is also delayed.
• Apply the ready-mix within the working time in one working step if possible until the desired layer thickness is achieved.
  By using a squeegee and a de-aeration broom, a smooth, even surface is obtained which usually does not need to be sanded.
• During the setting of the levelling compound, draughts and intensive sunlight must be avoided.
  This can lead to a too fast withdrawal of moisture, which "burns" the filler layer, pulverizes the surface edge zone and shrinkage cracks can occur.
• When laying on underfloor heating, the heating must be kept in operation for 3 days before, during and up to 7 days after laying with a surface temperature of 18 - 22°C.
  

Working conditions:
Required surrounding temperature: min. 18°C.
Material and subfloor temperature: min. 15°C.
Relative humidity: 35 - 75%, recommended <65%.

Textile coverings and parquet can be applied directly to the leveled area, provided they are even. Other floor coverings require a fine levelling with suitable Eurocol levelling compounds.