• Very low emissions
• Emicode EC 1PLUS
• Dust-free
• Fast-curing (meaning that the surface can be finished quickly)
• Spreadable to virtually 0 mm
• Maximum layer thickness 50 mm
• Stable
• Very high compressive strength
• Very smooth finishing
• Chromate-free
  

• Ideally suitable for filling deep grooves.
• For smoothing and repairing both cement-based and gypsum-based indoor floor surfaces.
• For filling holes, grooves and irregularities in both cement-based and gypsum-based floors and walls and other stony surfaces.
• Fast-curing and quick-drying, so that the surface can be finished quickly with a levelling compound, floor covering or ceramic tiling, for example.
• Not suitable for wet areas and/or outdoor applications.
• Suitable for wet areas if the surface is finished in accordance with the guidelines of the Eurocol watertight tiling system.
  

(floor and wall)

• 946 Europlan Hybrid Repair can be applied to any rigid, pressure-resistant and tear-resistant cement-based or gypsum-based surfaces as well as to other stony surfaces. The substrate must also be clean, permanently dry and free from grease and dirt, in accordance with the requirements of DIN 18365.
• Make the floor thoroughly dust-free after sanding with an industrial vacuum cleaner. Then prime cement-based floors with 044 Europrimer Multi and apply 043 Europrimer Alphy to gypsum-based floors and allow to dry sufficiently. In both cases, apply the primer using a fur roller.
• Prime smooth and closed subfloors, such as tile floors, granito, terrazzo, asphalt floors, bituminous substrates and sanded, old (waterproof) adhesive residues with 044 Europrimer Multi using a foam roller.
• When filling holes, grooves and irregularities in cement-based floors and walls, thoroughly dust them first, then prime with 044 Europrimer Multi and apply 043 Europrimer Alphy to gypsum-based floors and walls and allow to dry sufficiently.
• Always consult our technical product information sheets beforehand. In case of doubt about the correct application to use, please contact our Technical Advice department.

• Add 23 kg of 946 Europlan Hybrid Repair to 5.5 litres of cold and clean tap water.
• Mix the mortar mechanically with the Eurocol 855 Mixer into a smooth and lump-free mass.
• Apply the mortar within 10-15 minutes using a smoothing trowel.
• Protect the newly repaired parts against draughts and direct sunlight.
• After around 60 minutes, the repaired areas can be primed and finished with a levelling compound, for example.
• If desired, 946 Europlan Hybrid Repair can be cut at a 1:3 ratio with 846 Quartzsand when applied in a layer thickness greater than 50 mm (max. 7 kg 846 Quartzsand to 23 kg 946 Europlan Hybrid Repair.
• For detailed information on safety measures, please refer to the safety data sheet.
  

Working conditions:
Required surrounding temperature : 18 - 23 °C.
Temperature for material and subfloor : min. 15° - max. 20 ºC.
Relative humidity : 40 - 70%.

Underfloor heating systems:
946 Europlan Hybrid Repair can be applied to underfloor heating constructions. The start-up protocol of the underfloor heating must be fully executed in advance in accordance with the supplier’s guidelines. Switch off the heating one day before starting the work, then switch the heating on again at least 24 hours after levelling the subfloor, in steps of a maximum of 5 °C water temperature per day. Ensure that the floor temperature does not exceed 29 °C.