• High quality PUR-acrylic dispersion-based parquet lacquer with good spreading properties.
• To use for durable sealing of all kinds of permitted standard wooden floor.
• For use in living areas with intensive use and in commercial use with strong mechanical and chemical stress.
• Wear resistant class C according to Austrian standard ÖNorm C 2354.
• A full structure without primer is possible in many cases.
• For interior use.
• The product can be used on underfloor heating.
• Meets anti-slip rate R9 according to BGR 181 in combination with 873 Aqua Lacquer additive.
• Corresponds to the toy standard DIN EN 71-3 Migration of certain elements.
• Very low VOC emissions. EMICODE EC 1 Plus.
• Emission tested building product according to DIBt principles. 
• Declared by baubook, "ecological building product".

• The surfaces to be sealed must be clean and free of residues of oil, wax, silicone and other adhesion-reducing layers.
• Joints are closed with suitable Eurocol joint sealant. The fine sanding depends on the type of wood. The surface and edge sanding must be levelled out by means of a sanding grid.
• Use a Eurocol primer with barrier effect (e.g. for exotic woods, smoked oak, etc.) or to minimise absorbency and edge gluing (e.g. upright lamella parquet, parquet on sprung floors or on underfloor heating).
• Alternatively in many cases the product can be used as primer and top coat as one.
• In case of defects, objections are to be reported in writing.

Before use, temper the product according to the processing conditions.

• Stir before use!
• Add the appropriate lacquer to a mixing container. Use a scraper grid during application.
• Application to be done with a Eurocol stainless double-sided spatula 27 cm or a new, clean Eurocol Aqua microfiber roller 25 cm.
• The application to avoid any footprints on the floor.
• Do not apply more than two roller coats of lacquer in one day.
• To achieve uniform surface, apply the lacquer twice cross-wise or a uniform roller application with subsequent top coat application with roller.
• Eurocol recommends 2-3 roller applications.
• In the same day, do not apply the product more than twice.
• Drying time in-between layers is approx. 4 hours but not more than 24 hours.
• The surface needs to be sanded with an abrasive grid 100 or 120. Remove the dust with an industrial vacuum cleaner.
  Intermediate sanding improves the surface finish. Remove dust remains on the sanded surface.

During the drying process, even ventilation must be ensured. Draughts and direct sunlight must be avoided.

Rare woods, bleached ash, acacia, cherry, exotic woods or smoked oak must be primed with a blocking primer because of possible discolouration or streaking caused by ingredients or the smoking process.

Recommended primers:

Eurocol 883 Europrime Perfect   
Rollable and trowelable, Low side-bonding. High neutrality of the wood tone. Long wet-on-wet workability (rollability). No visible seams during rolling and filling. 
Eurocol 857 Europrime Block     
Exclusively for rolling. Especially for exotic woods, smoked oak and for renovation work. Pronounced tinting in woods that are sensitive to this, such as oak, beech, etc.

Working conditions:
Required surrounding temperature: min. 18°C.
Material and subfloor temperature: min. 15°C.
Relative humidity: 35 - 75%, recommended <65%.

To achieve the anti-slip class R9, add the homogenized Eurocol 873 Aqua lacquer additives to the aqua lacquer after its homogenization and mix well by shaking and proceed according to the application instructions of the lacquer. The mixture with aqua lacquer must be processed within one day. In this case, the mixture must be shaken regularly to prevent the setting of the structural agent during processing.