• Very low emission  
• Emicode EC 1PLUS
• Easy and safe to apply
• Non-flammable
• High initial adhesion strength
• Favourable spreading capacity
• Fast bonding
• Roller-castor-chair resistant according to DIN EN 12529
• The product can be used on underfloor heating.
• Shampoo resistant according to RAL 991 A2.
• For indoor use.
• Declared by baubook, "ecological building product"

For installing fillerfree carpet polyolefin backed carpet hessian-backed carpet synthetic backed carpet needlefelt. on absorbent subfloors:

• screwed wood-based panels (V100 P4 - P7, OSB 2 -4)
• sand cement screed
• anhydrite floors.

• 609 Eurostar Tex is suitable for any type of subfloor and on old, sandpapered adhesive residues, that has a good tensile and compression strength. The subfloor should also be even, clean, permanently dry and free from grease and dirt, according to the requirements of BS 8203 or DIN 18 365.
• Only use pervious floor coverings on impervious subfloors.
• When installing fillerfree carpet and polyolefin backed carpet on impervious subfloors apply a 2 mm levelling compound layer.
• In advance always seek our technical data sheets. In doubt about the application ask for technical advice.

• Old adhesive residues should be water-resistant and sandpapered beforehand.
• Thereafter make the subfloor dust-free with an industrial vacuum cleaner.
• Apply the adhesive with a regular notched adhesive spreader (Eurocol spreader no. 850/B1). In case of strong structured back qualities and/or adhesive residues use a large size spreader (spreader B2 or B3).
• On absorbent subfloors apply the floor covering directly into the wet adhesive. On low absorbent subfloors keep a waiting time of 10 - 30 minutes (depending on porosity subfloor, temperature and relative humidity).
• Roll the floor covering carefully. Sheet-ends and longitudinal joints are to be pressed firmly.
• On low absorbent subfloors, in case of impervious back qualities and/or when circumstances are less ideal, rolling and pressing should be repeated after approx. 15 minutes (depending on temperature and relative humidity).
• Remove fresh adhesive spots immediately with water.

Further information:

• Keep out of reach of children.
• Keep area thoroughly ventilated during and after processing and drying.
• When processing do not eat, drink or smoke.
• In case of contact with eyes or skin, rinse immediately with plenty of water.
• Do not empty into drains, surface water or onto soil.
• Only hand in packaging without rest material for recycling purposes. Dried rest material can be disposed of as domestic waste.
• Contains methylchloroisothiazolinone and methylisothiazolinone (3:1) and benzisothiazolinone . May produce an allergic reaction.

Working conditions:
Required surrounding temperature : 18 - 23 °C.
Temperature for material and subfloor : min. 15° - max. 20 ºC.
Relative humidity : 40 - 80%.

Underfloor heating systems:
609 Eurostar Tex can be applied on underfloor heating systems. The startprotocol of the floorheating needs to be completly executed in accordance with the directives of the supplier. Turn off the heater 24 hours before application. Do not heat again until at least 24 hours after installation, in steps of maximum 5 °C water temperature per day.