• High quality, rollable, after drying permanently self-adhesive coating for full area fixation of vinyl and textile floor coverings (also with
  felt backing).
• For laying on standard-compliant, fully levelled, absorbent subfloors and non-absorbent (also existing, cleaned, full- area glued down floor-coverings) subfloors.
• Ideal for private use in do-it-yourself application when easy floor covering removal (e.g. for renovation) is required.
• Non-flammable
• Permanent high adhesion
• Easy removal
• Favourable spreading capacity
• The product can be used on underfloor heating.
• Suitable for use with chair castors according to DIN EN 12529.
• For indoor use. 
• Very low emission EMICODE EC 1PLUS.
• Declared by baubook, "ecological building product".

• cushion vinyl
• PVC backed carpet. 

• 546 Eurofix Tackifier is suitable for any type of subfloor that has a good tensile and compression strength.
• The subfloor should also be even, clean, permanently dry and free from grease and dirt according to the requirements of BS 8203 or DIN 18 365.
• When applying cushion vinyl all non-self-supporting or self-supporting, not or insufficiently ventilated floors above the ground and non-self-supporting floors below the ground, but above the groundwater level, must be provided with a water vapour-tight moisture barrier (e.g. 3 coats of 026 Euroblock Multi).
• When applying cushion vinyl on non-self-supporting floors below the ground level and in the groundwater, a sufficiently thick coating of cast asphalt must be applied.
• In advance always seek our technical data sheets. In doubt about the application ask for technical advice.
• For levelling the substrate use recommended Eurocol levelling compounds/primers.
• Existing floor coverings must be firmly connected to the subfloor.
• Parquet flooring must be sealed free of defects and waterproof.
• Old separating layers, such as floor polish, old care product films, which can reduce adhesion, must be removed.
• To make it easier to remove the fixation when changing the flooring at a later date, it is recommended that after removing old care products, the existing flooring is treated again with suitable Eurocol care products (e.g. 898 Eurocare Longlife) before the fixation
  is applied.
• In advance always seek our technical data sheets. In doubt about the application ask for technical advice.

Before use, temper the product according to the processing conditions.

Stir before use!

• Apply 546 Eurofix Tackifier on the subfloor with a lambswool roller or fine-notched adhesive spreader in the recommended quantity.
• Wait for the adhesive to dry (fully transparent) before installing the floor covering.
• Thereafter roll the floor covering well and press firmly.
• Before applying 546 Eurofix Tackifier on old and smooth floor covering check the adhesion of the floor covering. Thereafter degrease the old and smooth floor covering thoroughly with 014 Euroclean.
• When fixing on anhydrite floors apply a coat 049 Europrimer ABS with a lambswool roller and allow to dry for 24 hours.
• In general the floor covering can easily be removed from the subfloor afterwards.
• Remove fresh adhesive spots immediately with water.

Working conditions:
Required surrounding temperature : 18 - 23 °C.
Temperature for material and subfloor : min. 15° - max. 20 ºC.
Relative humidity : 40-70%.

Underfloor heathing systems:
546 Eurofix Tackifier can be applied on underfloor heating systems. The startprotocol of the floorheating needs to be completly executed in accordance with the directives of the supplier. Turn off the heater 24 hours before application. Do not heat again until at least 48 hours after installation, in steps of maximum 5 °C water temperature per day.