• Non-flammable
• Good moisture resistance
• High initial adhesion strength
• Favourable spreading capacity
• Roller-castor-chair resistant 
• Very low emission
• EMICODE EC 1PLUS
• Emission-tested construction product according to DIBt principles.
• Declared by baubook, "ecological building product".

For installing:

• linoleum in sheets
  
• corkment.

• 514 Eurosafe Lino is suitable for any type of subfloor that has a good tensile and compression strength.
• The subfloor should also be even, clean, permanently dry and free from grease and dirt, according to the requirements of BS 8203 or DIN 18 365.
• When installing on impervious subfloors apply a 2 mm levelling compound layer.
• In advance always seek our technical data sheets. In doubt about the application ask for technical advice.

• Apply the adhesive with a regular notched adhesive spreader (Eurocol spreader no. 850/B1) (when installing Colovinyl use adhesive spreader no. 852/A2).
• On absorbent subfloors apply the floor covering directly into the wet adhesive. On low absorbent subfloors keep a waiting time of approx. 10 minutes.
• Roll the floor covering carefully; first widthwise, then lengthwise.
• Do not double-stick bight marks. Lay bight marks into the wet adhesive as usual.
• Sheet-ends, bight marks and longitudinal joints are to be pressed firmly.
• On low absorbent subfloors and/or when circumstances are less ideal, rolling and pressing should be repeated after approx. 15 minutes.
• Remove fresh adhesive spots immediately with water.

Working conditions:
Required surrounding temperature : 18 - 23 °C.
Temperature for material and subfloor : min. 15° - max. 20 ºC.
Relative humidity : 40 - 80%.

Further information:

• Keep out of reach of children.
• Keep area thoroughly ventilated during and after processing and drying.
• When processing do not eat, drink or smoke.
• In case of contact with eyes or skin, rinse immediately with plenty of water.
• Do not empty into drains, surface water or onto soil.
• Only hand in packaging without rest material for recycling purposes. Dried rest material can be disposed of as domestic waste..
• Product residues and cleaning water drains according to local applicable environmental rules and do not drain in the sewer.
• Avoid contact with eyes and skin and use proper protecting equipment (see our safety sheet).

Underfloor heating systems:
514 Eurosafe Lino can be applied on underfloor heating systems. The startprotocol of the floorheating needs to be completly executed in accordance with the directives of the supplier. Turn off the heater 24 Underfloor heating systems:hours before application. Do not heat again until at least 24 hours after installation, in steps of maximum 5 °C water temperature per day.

Contains methylchloroisothiazolinone and  methylisothiazolinone (3:1) and benzisothiazolinone. May produce an allergic reaction.