• Ready for use
• Easy to process
• Impregnating property
• Adhesion enhancer
• Solvent-free
• Neutral smell

• The 305 BetonDesign and 395 FloorDesign must have been created in accordance with the steps described in the instruction manual. The surface must be clean, consistently dry, and free from grease, dirt and dust.
  

• Shake well (minimum 1 minute) before use.
• When applying the product to the floor wear shoe covers to prevent foot prints.
• 300 BaseCoat is applied by means of a 9 mm microfiber paint roller. This coat has impregnating capacity and ensures proper adhesion of the 310 FinishCoat.
• The coating must be applied evenly and without pressure across the entire surface. We advise that you roll the coating in every direction.
• After a drying time of at least 2 hours, yet no more than 24 hours, the 310 FinishCoat must be applied also by means of a 9 mm microfiber paint roller. Allow a minimum drying time of 12 hours.
• It takes approximately 8 days for the finishing coat to become resistant. Thus it is important that within these 8 days the floor does not get stained and/or damp, as this may lead to a damaged finishing.
• Fresh product stains should always be removed with water immediately.
• Always consult our technical production information sheets first. When in doubt about the use of the product, please contact our Technical Help Desk.
• Product residues and cleaning water drains according to local applicable environmental rules and do not drain in the sewer.
• Avoid contact with eyes and skin and use proper protecting equipment (see our safety sheet).

Contains methylchloroisothiazolinone and methylisothiazolinone (3:1). May cause an allergic reaction.

Conditions for processing:
Desired room temperature : 18 - 23 °C
Temperature for material and subfloor : min. 15° – max. 20 °C
Relative humidity : 40 - 70%.