• Fast setting (approx 5 hrs.) 2-component epoxy resin for blocking non-pressing residual moisture in cement screed and concrete.
• For strengthening surface edge zones. Suitable as bonding layer on mastic asphalt, ceramic tiles, wood-based panels or as a moisture protecting layer of moisture sensitive subfloors.
• To cover fixed, water-soluble adhesive residues, for the production of epoxy mortars in combination with Eurocol 846 Europlan Sand/847 Europlan Sand fine. 
• For blocking non-residual moisture in unheated cement screeds without limiting residual moisture.
• For indoor use only.
• Very low emission certified EMICODE EC 1 Plus. 

• for blocking non-pressing residual moisture in cement screed and concrete without limitation of residual moisture,
• for strengthening surface edge zones.
• Suitable as bonding layer on mastic asphalt, ceramic tiles, wood-based panels,
• suitable as a moisture protecting layer of moisture sensitive subfloors, to cover fixed, water-soluble adhesive residues,
• for the production of epoxy mortars.

• The substrate must be pressure- and tension-resistant, free of cracks and dust, even and free of layers that reduce adhesion.
  Adhesion-reducing layers, old material residues must be removed by suitable mechanical measures in accordance with the specifications of DIN 18365/DIN 18356.
  Old fixed floors, such as ceramic tiles, terrazzo, stone floors, must be thoroughly cleaned and sanded matt after drying.
• Smoothed concrete floors, cement screeds and vacuum concrete are to be shot-blasted.
• Cracks or joints (except structural expansion joints) are to be closed with Eurocol Europlan 913 Silicate sealing compound.
• In case of defects, objections are to be reported in writing.

Before use, temper the product according to the processing conditions.

• Add comp. B to comp. A, therefore cut through the synthetic cap and bottom of component B with a screwdriver. Thereafter unlock the packaging, in this way the hardener will easily penetrate into the resin.
• The hardener component must be completely emptied into the resin component and mixed homogeneously with a suitable stirrer for approx. 5 minutes, also in the wall and bottom areas of the containers. Immediately decant into a clean container and mix again.
• Apply the mixture immediately with a lambswool roller. Avoid puddles.
• On strong porous subfloors as well as application as a DPM apply after 5 - 15 hours a second coat.
• To avoid adhesion problems of levelling compounds sprinkle the last coat always with 846 Quartzsand. As a DPM sprinkle the second coat.
• After setting the primer remove excess 846 Quartzsand with a broom or industrial vacuum cleaner.
• Lower temperatures < 10 °C will increase the finale bond strength significantly.

Use as reaction mortar:
By adding Eurocol 846 Europlan Sand and/or 847 Europlan Sand fine (depending on the desired layer thickness and viscosity), the product can be used to produce a reaction mortar as a levelling mortar to stable filling mortar (mixing ratio mass% 1 : 0.8 to 1 : 9 - resin : sand). The freshly applied reaction mortar must be sanded in the same way as a primer. 

It is advantageous if the produced mortar is applied to the freshly applied primer, wet-in-wet. The flanks of adjacent screeds should also be primed.

Working conditions:
Required surrounding temperature : min. 18°C.
Temperature for material and subfloor : min. 15°.
Relative humidity : 35 -75%.

Pay attention to BG Chemical information leaflet M023 “working with Polyester and epoxy resins”, DGUV Information 201-062 "EP resins in the construction industry" and BGR227 work with epoxy resins.
When using as a moisture barrier, make sure there is enough ventilation at skirting and behind cupboards.
Only mix complete bucket contents!